Custom LED Trim Lights Designed For Your Honda Goldwing GL1800

FAQs

1.  What is the cost to have this custom work done?

2.  What are the lens colors to choose from?

3.  How long does it take?

4. Is the trim difficult to remove?

5.  Is it hard to install?

6.  Can other patterns or configurations be done in the trim?

7.  Do you have any trim pre-done for exchange?

8.  Is there a guarantee on the LED’s?

9.  Where are you located?

1.  What is the cost to have this custom work done?

The cost to have the same exact pattern as shown on the yellow bike pictured is $325.00 return shipping included in either red or amber LED’s or a combination of both if desired. Turn signals may be incorporated at no extra charge. Other LED colors are available at an extra cost.

2.  What are the lens colors to choose from?

Red, Yellow, Amber, Clear and Blue. The blue lens can only be used with the blue LED’s however and is recommended to be on a switch so they can be turned off. All the other lens colors can use either the red or amber LED’s behind them. The lens color only comes into play when the LED is off. When the bike is running you only see the emitted light. When the bike is off you see the lens color. You can select the lens color to either blend in or contrast with the color of your bike.

3.  How long does it take?

Approximately one week from when the trim is received for the work to be completed the trim will be returned.

4. Is the trim difficult to remove?

No. There is a link to a trim removal tip on the general information page for you to refer to.

5. Is it hard to install?

It is not hard if you study and follow the instructions. It is not plug and play. There is some wiring involved. On the plus side there is no splicing or plugging into the rear lights wiring. You do not have to take apart the bike's rear lights. Included will be Installation instructions along with wiring diagram and pictures.

Trim Removal Tip

Copyright © WingLites.com 2003-2008 All rights reserved

Masterful Designs